Just returned from the local indoor gun range.
I’ve been wanting to rework my AR’s, so I’ve been swapping parts, buying a few new things, putting a few old things on the shelf. Still not at my 100% ideal setup, but close enough for now… especially since more changes require money, and right now I’m drained.
So the range trip was for two things:
- Re-validate the 6.8 SPC to ensure it was still holding zero.
- Zero the rebuilt Bushmaster
The Wilson Combat 6.8 SPC upper now rests atop a Rock River Arms lower, still with the RRA 2-stage match trigger. Shooting the Silver State Armory 6.8 SPC 85 grain Barnes TSX tac-load, shot just fine. If anything, it’s evident that I am the weakest link. 🙂
The main focus was to work on the Bushmaster. I wanted a lighter gun, so this is a minimal setup. I started zeroing it at 50 yards with some Georgia Arms “canned heat” 55 grain FMJ, just to get things on paper. A lot of twisting of knobs and adjusting the front sight post, and things were looking good. I switched to Hornady TAP FPD .223 Rem 75 grain. A slight tweaking to the sights and things were good. Then I got to the real meat of it all: the Aimpoint Comp M4s. A bit of adjusting, a bunch of playing and oh… what a sweet sweet optic.
The thing is? I can’t tell you much about it here. I received the Aimpoint on T&E for TacticalGunReview.com. So my experiences and results are going to be written up there, not here. I’m working on the write-up, but I have a little more field work to do before I publish it. When I do have it all up, I’ll of course link to it from here. I’ll just say that yeah, I dig that Aimpoint. 🙂
And… if you could guess by my previous post, going to the local indoor gun range is always an adventure. I prefer to go mid-week first thing in the morning: i.e. about as dead as it can be. But due to schedules, I had to go in the afternoon. The place was busy and I had to wait for a lane. Once I got one… boy, it was noisy in there (this is why you wear both ear plugs and ear muffs). It was also a continued reaffirmation as to why I generally try to surround myself with competent shooters. While most of the folks there weren’t bad, there was much room for improvement. Folks, this is why it’s essential to get good training. If you really want to tighten up those groups, if you want to stop throwing all your shots low-left, find a good teacher… I happen to know one.
As for some tips:
- Again ladies, you may have nice boobs, but for your own well-being, cover them up. Hot brass down the shirt is no fun.
- If you want to thumb-cock your revolver that’s fine, but there’s no need to point it up at the ceiling every time you do so.
- When you (un)case your firearm, please do it on the benches so the muzzle points downrange… not on the floor behind the line so the muzzle points towards everyone on that side of the line.
- We all know about ear/hearing protection, but eye protection is important too.
- Wash your hands before you touch anything you care about: your eyes, mouth, food, etc.. Not that there was food on the line, but many people were handing guns and ammo, then just leaving. There’s a sink, use it.
- If you want to borrow the extra benchrest that’s sitting unused next to me, all you need to do is ask.